Troubleshooting - HP PL5060N Guia Del Usuario

Refer to this section if you have viewing, picture, sound, remote, or startup problems with your TV.
Startup questions
Symptom
I do not hear sound at power-on,
even though there is an image.
I do not see an image at power-on.
There is no power.

Troubleshooting

Remedy
Are the two speaker wires connected at the speaker and on the
■
TV, and:
Is the volume too low? Press the Volume button.
■
Is mute turned on? Press the Mute button, or the Volume button.
■
Are the connections to the input signal source component correct?
■
Double-check that the cables are properly inserted in the color-coded
connectors.
Is the input source powered on? Turn on the set-top box, DVD player,
■
or other component you are trying to view.
Is the correct input signal source selected? Press the Source button on
■
the remote control and confirm the source is selected.
Press the Menu button on the remote control or side of TV:
■
If the OSD appears, check the cables to the input source and
■
press the source button on the remote control or side of TV to
choose the input source.
If the OSD does not display, see the next symptom, "There is no
■
power."
Did the HP logo display when you turned on the TV? (TV must be in
■
Standby Mode Low power to see the logo; refer to "Selecting the
Standby Mode (Power Control)" on page 40.)
If yes, check the cables to the input source and press the source
■
button on the remote control or side of TV to choose the input
source.
If no, see the next symptom: "There is no power."
■
Press the Power button on the remote control unit.
■
If the indicator on the TV is off, press the Power button on the TV.
■
Is the AC cord disconnected? Make sure both ends of the power cord
■
are plugged in.
Is there power coming from the outlet? Plug in a functional lamp or
■
other electrical device into the same outlet as the TV to make sure
there is power coming from the outlet.
If using a power strip, make sure it is turned on.
■
49
Troubleshooting