Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STORING UNIT
SHORT TERM (1-6 months):
1. Add John Deere Fuel Conditioner & Stabilizer
(or equivalent) at the specified concentration.
2. Run the unit for two (2) minutes to ensure the mixed
fuel is in the entire fuel system. Close the fuel valve
and run the unit until it stops.
3. Remove the spark plug, pour 1-2 teaspoons (5-10cc)
of engine oil into the cylinder, slowly pull the starter
handle 2 or 3 times, reinstall the spark plug and tighten
securely.
4. Clean the exterior surface of the unit and apply a rust
inhibitor.
5. Store the unit in a dry, well ventilated place.
LONG TERM (More than 6 months):
1. Add John Deere Gasoline Conditioner & Stabilizer
(or equivalent) at the specified concentration.
2. Run the unit until the fuel tank and carburetor
are dry. As the engine is beginning to die, move the
choke lever to the choke position.
NOTE: Turn off the idle control to decrease the run time.
3. Remove the spark plug, pour 1-2 teaspoons (5-10cc)
of engine oil into the cylinder, slowly pull the starter
handle 2 or 3 times, reinstall the spark plug and tighten
securely.
4. Clean the exterior surface of the unit and apply a rust
inhibitor.
5. Store the unit in a dry, well ventilated place.
WARNING: FUEL SHOULD BE DRAINED IN A
WELL VENTILATED AREA AND STOREDIN
A CONTAINER APPROVED FOR GASOLINE.
Operator's Manual

Storage

Service
29

Publicidad

Tabla de contenido
loading

Productos relacionados para john deer AC1-CG16H

Este manual también es adecuado para:

Ac2-cg35hAc2-cg35h-pAc2-cg35h-30Ac2-cg40s-30

Tabla de contenido