Error Message; Final Operations - Motostar SLS24 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 134

ERROR MESSAGE

 The error messages are shown on the display.
Er1
The M1 motor's self-learning of the gate travel is interrupted; check whether the motor is properly connected and functioning.
The M2 motor's self-learning of the gate travel is interrupted; check whether the motor is properly connected and functioning.
Er2
Er3
Encoder is broken.
Services-test error; check whether the safety devices are properly connected and functioning.
Er4
Er5
Insuffi cient operating time; check the F22 set time, it may need extending to complete the duty cycle.
Er6
Maximum number of obstructions detected.
Overheated transformer - the gate leaves stay open after an "open" command.
Er7
CO
Contact 1-2 (STOP) unused; deactivate the contact from function F1.
C1/2/3/4
Contacts CX and/or CY unused: deactivate contacts from functions F2 and/or F3.
 Flashing red LED: the control board is calibrated to the gate travel.

FINAL OPERATIONS

Once the connections and commissioning are done,
fasten the cover the control panel by using the
supplied hardware.

Publicidad

Tabla de contenido
loading

Productos relacionados para Motostar SLS24

Tabla de contenido