Craftsman 917.881150 Manual Del Propietário página 8

ASSEMBLY / PRE-OPERATION
INSTALL DISCHARGE CHUTE / CHUTE ROTATER
HEAD (See Fig. 7)
NOTE: The multi-wrench provided in your parts bag may
be used to install the chute rotater head,
1. Place discharge chute assembly on top of chute base
with discharge opening toward front of snow thrower,
2, Positionchuterotaterheadoverchutebracket. If neces-
sary, rotate chute assembly to align square and pin on un-
de rside of chute rotate r head with holes in chute bracket.
3. With chute rotater head and chute bracket aligned,
position chute rotater head on pin and threaded stud
of mounting bracket,
4. Install 3/8 washer and Iocknut on threaded stud and
tighten securely.
ALIGN CHUTE ROTATER HEAD
WITH MOUNTING
BRACKET BEFORE
TIGHTENING
LOCKNUT
"_'_ 3/8 LOCKNUT
(_ 3/8 WASHER
PIN
STUD
CHUTE
BRACKET
ROTATER HEAD
CHUTE MOUNTING
ROTATER HEAD BRACKET
FIG. 7
INSTALL CHUTE DEFLECTOR REMOTE CONTROL
(See Figs. 8 and 9)
1, Install remote cable bracket to discharge chute with
5/16-18 carriage bolt, flat washer and 5/16-18 Iocknut
as shown, Tighten securely.
2. Install remote cable eyelet to chute deflector with
1/4-20 shoulder bolt, nylon washer and 1/4-20 Iocknut
as shown. Tighten securely,
3. Install spring hooks between hex nuts on chute rotater
head and into hole in chute deflector as shown,
CHUTE SPRING 1/4-20
BOLT
NYLON
WASHER
\ HOOK BETWEEN
CABLE HEX NUTS
EYELET ON CHUTE
ROTATER HEAD
5/16-18
CARRIAGE
BOLT
CABLE
BRACKET
FLAT
WASHER
5/16-18
LOCKNUT
FIG. 8
CHUTE DEFLECTOR
CONTROLLEVER
FIG. 9
CHECK TIRE PRESSURE
The tires on your snow thrower were overinflated at the fac-
tory for shipping purposes, Correct and equal tire pressure
is important for best snow throwing performance.
• Reduce tire pressure to 14-17 PSI (19-24,5 N-m),