Rubi TC 180 Manual Del Usuario página 15

make exposed metal parts of the tool "live" and
shock the operator.
4. Always use blades with correct size and
shape arbor holes. Blades that do not match
the mounting hardware of the saw will run eccen-
trically, causing loss of control.
5. Never use damaged or incorrect arbor
flanges or bolts. The arbor flanges and bolt
were specially designed for your saw, for best per-
formance and safety of operation.
6. Maintain a firm grip on the saw and posi-
tion your body and arm in a way that allows
you to resist KICKBACK forces. KICKBACK
forces can be controlled by the operator, if proper
precautions are taken.
7. Do not use a dull or damaged blade.
8. Use only recommended blades, rated at the
machine's maximum rated RPM or higher with
correct arbor hole.
9. Tighten blade retaining bolt and all clamps
before operating.
10. Check the inside surfaces of the arbor flan-ges
as well as the sides of the blade for freedom from
any foreign matter.
11. Check the blade for cracks or other dam-
age before operation. Replace cracked or da-
maged blade immediately. Carry out a test run
without load for at least 30 seconds before use.
12. Never start the tool with the workpiece
against the blade.
13. Allow the motor to achieve full speed be-
fore cutting.
14. Important: After completing the cut, re-
lease power switch and wait for coasting blade to
stop completely before putting the saw down.
15. Never operate the tool in an area with
flammable solids, liquids, or gases. Sparks from the
commutator/carbon brushes could cause a fire or
explosion.
16. There are certain applications for which
this tool was designed. The manufacturer
strongly recommends that this tool NOT be
modified and/or used for any application other
than for which it was designed. If you have any
questions relative to its application DO NOT use
the tool until you have written the manufacturer
and have been advised.
17. Only use the machine for cutting in stone,
concrete or masonry.
18. Use the auxiliary handles supplied with the
tool. Loss of control can cause personal injury.
19. Use a residual current device (PRCD) to
protect from current surges.
20. Keep power supply cord clear from the
working range of the machine. Always lead
ENGLISH
ORIGINAL INSTRUCTIONS
21. Immediately switch off the machine if un-
22. Only use and store diamond blades accord-
23. Pay attention to the dimensions of the
24. Take care to avoid hidden electric lines, gas
25. The dust that arises when working with
WARNING
Only use diamond blades of diameter 180mm with
7/8"(22.23mm) arbour hole. Thickness must be be-
tween 1.0 and 2.6mm. Diamond blades may be of the
solid, turbo or segmented type. If of the segmented
type, the peripheral gaps between the segments must
not be more than 10mm and must be with a negative
rake angle.
Warning: Do not use bonded abrasive blades with
this saw.
Warning: Do not use toothed saw blades with this
saw.
Store the saw and accessories in such a way that the
blade and other parts of the saw are not subjected
to damage.
the cable away behind you.
usual vibrations or if other malfunctions
occur. Check the machine in order to find out
the cause.
ing to the Manufacturer's instructions.
blades. The diameter of the center bore must
engage the arbor without play. If not use any nec-
essary reduction pieces or adapters (supplied with
the blade) to ensure a proper fit.
and water pipes. Check your working area, e.g.
with a metal detector before commencing work.
this tool can be harmful to health. Use a dust
absorption system and wear a suitable dust pro-
tection mask and remove deposited dust with a
vacuum cleaner.
15