Rubi TC 180 Manual Del Usuario página 17

Inner Flange
Blade
NOTE: Use blades that have an arbor bore
which can fit, and that are rated for the ma-
chine's maximum rated speed or higher.
REMOVING THE BLADE:
DISCONNECT TOOL
SOURCE.
Removal is the opposite of installing the blade.
TO ADJUST DEPTH OF CUT
DISCONNECT TOOL
SOURCE.
Loosen the Depth Stop Lever by pushing it forwards
and adjust the depth of cut to the desired amount.
Then retighten the Depth Stop Lever. See Fig.3
Depth Scale
ENGLISH
ORIGINAL INSTRUCTIONS
Outer Flange
Washer
Arbor Bolt
Fig.2
FROM POWER
FROM POWER
Depth
Stop Lever
Fig.3
HOW TO USE THE SIGHTING NOTCH
To aid in free-hand cutting, sighting notches are lo-
cated at the front of the base plate.See Fig.4.
Sighting notches
VACUUM DUST COLLECTION
There is a vacuum port provided on the blade cover
to collect dust when operating.
Simply attach the vacuum cleaner hose to the va-
cuum port. See fig. 5. Keep the Cap in place when
not in use.
.
Vacuum Port Cap
WATER FEED SYSTEM
The water feed system allows the machine to cut
more effectively. Ensure that a PRCD interrupter
unit is always used.
Mount a Quick Release Water Coupling (not in-
cluded) to the water supply hose. Adjust the Water
Valve for the desired amount of water flow.See Fig.6.
Fig.4
Fig.5
17