Electrical Connection - Rubi TC 180 Manual Del Usuario

SPECIFICATIONS
Volts Watt
220-
1800 W
240V
180
55 mm.
mm.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage
indicated on the tool name plate. Under no circum-
stances should the tool be used when the power s
upply cabl e i s damaged. A damaged cable must be
replaced immediately by an authorized Customer
Service Center. Do not try to repair the damaged
cable yourself. The use of damaged power cables can
lead to an electric shock.
INTENDED USE
This saw is designed exclusively for wet or dry cut-
ting of stone, concrete and masonry. This machine
should not be used for cutting other materials. The
machine should not be converted or modified, e.g.
for any other form of use, other than as specified in
these operating instructions. The user shall be liable
for damages and accidents due to incorrect use.
EXTENSION CABLE
SIf an extension cable is required, it must have a
sufficient cross-section so as to prevent an exces-
sive drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead to
failure of the motor. The following table shows you
the correct cable diameter as a function of the cable
length for this machine. Use only U.L. and CSA
listed extension cables. Never use two extension
cables together. Instead, use one long one.
16
ENGLISH
ORIGINAL INSTRUCTIONS
n
22.23
5800
mm.
min-1
(7/8")
L
= 95,5
6.7 kg. PA
dB(A)
(14.74
L
= 106,5
WA
dB(A)
Lbs)
K
= 3 dB(A)
Longueur totale de
la rallonge (cm/feet)
750 cm / 25"
1500 cm / 50"
3000 cm / 100"
4500 cm / 150"
6000 cm / 200"
UNPACKING
Carefully remove the tool and all loose items from
the shipping container. Retain all packing materials
until after you have inspected and satisfactorily oper-
ated
the machine.
NOTE: An appropriate diamond blade must
be mounted to the machine before operating.
Refer to the section of this manual:
"INSTALLING THE BLADE"
CARTON CONTENTS
· Stone Cutting Circular Saw Machine
· Vacuum hose connector
· Parallel guide
· L-hex wrench
· Diamond blade 180 mm
DO NOT OPERATE THIS TOOL UNTIL
YOU READ AND UNDERSTAND THE
ENTIRE INSTRUCTION MANUAL.
INSTALLING THE DIAMOND BLADE
ENSURE THAT TOOL IS DISCONNECTED
FROM POWER SOURCE.
TO INSTALL THE BLADE:
1. Remove any accumulated debris in the
guards and around the arbor.
2. First mount the Inner Flange, then the
blade, ma-king sure the direction of rotation
arrow of the blade and the arrow on the ma-
chine are in the same direction.
3. Mount the Outer Flange, Washer and Ar-
bor Bolt.
See Fig.2.
Dimension du Câble
(AWG)
16
12
10
8
6