Systems Powered By The Psu 01; Error Leds; Powering Via Receivers; Cleaning - AKG PS 61 Modo De Empleo

4 Operating Notes
4.3 Systems Powered by the
Disconnect AC adapter!

4.4 ERROR LEDs

4.4.1 Powering via Receivers

4.4.2 Powering via PSU 01

5 Cleaning

9
2. On the Power Splitter to which you connected the antennas, set the CABLE
ATTENUATION switch to the position given in Table 1 in section 3.3.5.
3. Set the CABLE ATTENUATION switch on any other Power Splitter(s) you may use
in the system to "12 dB".
1. Check whether one or more receivers are connected to AC power via the supplied
PSU 01 AC adapter.
If so, disconnect all AC adapters from power and from the receivers to prevent
damage to the equipment.
2. Switch the PSU 01 ON. This overrides the power switches on the receivers and
both the Power Splitter(s) and the receivers will switch on automatically.
The POWER ON, BOOSTER A OK, and BOOSTER B OK LEDs on the Power
Splitter will illuminate.
The green status LEDs on the two booster antennas will illuminate.
3. On the Power Splitter to which you connected the antennas, set the CABLE
ATTENUATION switch to the position given in Table 1 in section 3.3.5.
4. Set the CABLE ATTENUATION switch on any other Power Splitter(s) you may use
in the system to "12 dB".
If the BOOSTER A or B ERROR LED on the Power Splitter illuminates, this means
that booster antenna A or B receives no supply voltage:
1. Check that each of the AC adapters powering the receivers is connected to both
AC power and the respective receiver.
2. Check that all receivers connected to the Power Splitter are switched ON.
If any receiver is OFF, switch it ON.
3. Check the antenna cables.
Should one of the antenna cables be shorted, replace it with a new one.
4. Check that all receivers are correctly connected to the Power Splitter.
Make any connections that may be missing.
1. Check that the PSU 01 is connected to AC power and the Power Splitter(s) and
switched ON. Check that all connectors are plugged in securely.
2. Check the antenna cables.
Should one of the antenna cables be shorted, replace it with a new one.
IMPORTANT: Also read the Instruction Manual for the PSU 01, particularly the section
on selecting power voltages and warnings.
To clean the Power Splitter surfaces, use a soft cloth moistened with methylated
spirits or alcohol.