True T-23DF-HC Manual De Instalación página 18

Tabla de contenido

Publicidad

TRUE
T-23DF-HC
FAILURE MODES AND EFFECTS ANALYSIS:
If unit is running warm, please review the list of below recommendations:
IS THERE SIGN OF ELECTRICAL POWER TO
THE UNIT?
1.
Is the electronic control illuminated?
2.
If you open the door, are the lights on, or is the fan operating?
3.
Are you able to hear the compressor cycling?
If the unit is connected to a dedicated receptacle, please insure the
fuse or circuit breaker supplying voltage to the receptacle is in the
"on" position.
ARE THE DOORS COMPLETELY CLOSING? (INSURE
GASKETS ARE IN GOOD CONDITION)
Doors must be enabling the door switch for the interior fans to
operate.
IF TEMPERATURE DISPLAY IS READING ABOVE THE
RECOMMENDED OPERATING CONDITIONS. IF SO,
PLEASE REFER TO BELOW:
Is the unit in defrost mode? – To confirm this, open the door of the
unit and push in the door switch with your finger. If the evaporator
fans (located in the interior ceiling) do not begin cycling when door
switch is in, then this designates that the unit is in defrost mode.
PLEASE NOTE THAT TEMPERATURE DISPLAYED IS NOT ALWAYS
REPRESENTATIVE OF PRODUCT TEMPERATURES. You should be
concerned with interior product temperatures only, thus checking the
temperature of an interior product is recommended if digital display
seems to be out of operating parameters.
17
ON MODEL T -23DF, THERE ARE 2 DOOR SWITCHES
– ONE LOCATED IN STANDARD POSITION ON TOP
OF DOOR AND ON LOCATED ON THE BOTTOM
DOOR.
Please insure that bottom louvered grill is installed properly and if this
has recently been removed for cleaning, please confirm that the cord
attached to the grill is connected to the ballast box.
CONFIRM THAT THE UNIT IS CORRECTLY LOADED
WITH PRODUCT – ALLOWING FOR PROPER
AIRFLOW WITH SUFFICIENT CLEARANCE INSIDE
OF THE UNIT.
THIS IS CRITICAL FOR PROPER CABINET OPERATION AND
CONSISTENT TEMPERATURE THROUGHOUT.
TRUE should you need a guide to proper loading of equipment.
For freezers, please note that this unit is designed as a holding freezer,
not a blast chiller – It is recommended that already frozen product
be loaded into the freezer.
FOR ANY OTHER FAILURE MODES THAT
ARE NOT LISTED, PLEASE CONTACT A TRUE
REPRESENTATIVE.
.
.
www
truemfg
com
Please contact

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido