MasterSun MAXIM Manual De Instrucciones página 19

Attention: If you find that there is no resistance when you pull out the nut of the
heavy duty anchor, then the heavy duty anchor has not enough anchorage. You
have to repeat the complete mounting with a minimum offset of 15 cm!
For correct mounting jacket of heavy duty anchor must be inserted completely, it
may not overlap! If necessary remove the anchor and drill the hole deeper.
Figure 4:
Insert heavy duty anchors as shown into the drilling holes.
Step 5: Fixing the brackets
Place the bracket on the screw protruding from the
wall. Then add flat washer and spring washer and
fix the bracket with lock nuts. Tighten them well.
It is also possible to fix the awning under a concrete
ceiling. If you want to fix the awning under a
concrete ceiling you must consult a professional
expert for this kind of mounting.
Drawing 5:
Bracket has been prepared to be fixed on a wall. Chose the whole you need to fix them according to
drawing.
Firmly tighten the bolts with a 17mm wrench: use an angulated ring spanner or better a
socket wrench with proper socket. Open-ended spanners or fork wrenches should not be
used, because of possible danger of slipping or damage of the nuts.
As soon as they are fully inserted, the brackets must sit firmly in the wall. If they are still
moving in any form, you must further tighten it.