MasterSun MAXIM Manual De Instrucciones página 20

Do not try to secure the wall brackets to loose wall stones or any surfaces that
are not absolutely firm connected to brickwork.
Make sure that brackets have been attached to wall firmly, so that they cannot be
pulled out when hanging on the awning.
Step 6: Install awning
After all three brackets have been mounted properly you can fix the awning. At least three ladders or
treads are required to install the awning in order to obtain the required height. Ensure that the
ladders/treads are firmly resting on the ground so that you cannot fall. Only use ladders/treads that are
suitable for such assembly work.
Insert the awning into brackets as shown in drawing below. Then immediately secure it with delivered
round head bolts to the brackets. Tighten the nut of the round head bolt firmly.
Drawing 6:
Fixation the bracket as figure6.1.then put the awning on the brackets as figure 6.2.then use Wrench to
tighten the bolts to keep the awning tightess as below figure 6.3
In order to put the awning on the brackets convenient, you can loose the Hangs Taiwan
briquetting in a appropriate position, but you have to tighten the bolts as soon as finish
putting on the awning .
Attention: you have to check again as again if all bolts tighten after install the
awning.
Remove the safety belt after mounting; otherwise the awning
cannot be extracted. Keep the belt; you can use it when storing the
awing.