Operatinginstructions - Craftsman 572.610830 Manual De Instrucciones

OperatingInstructions
_ lways pull the tool towardyou!
Do netpushit] Pushingthe bit
may cause it to break. Holdthe toolin a golf grip
with the tool positioned below the attachment and the
bit pointing upwards.
Onyour variable speed tool, recommendedtool speed
is 15.000-20,000 RPM's or speed setting 6 to avoid
damage to the bit. Onyour two speedtool,
recommended tool speed is "Low"to avoid damageto
thebit. Do not force the bit or put pressure on the
back of the tool to remove the grout. Let the speed of
the rotating bit do the work.
GroutRemoval Safety Warnings
Wear eye protection and dust mask. Inspect bit for
damage. When bit is installed, alwaysrun it at no-load
speed of the tool for one minute, asa damaged bit
witl break apart. Do not stand in front of or in line
with bit.
!
:Always use the tool with the depth guide positioned
flat against the material being cut.
The guide securely positioned on the material
improves stability and control of your tool.
The direction of feedwith the bit into the grout is
important. Always drag or pull the bit through the
grout line. The grout bit is not intended for "plowing"
through the grout andfeeding the tool in the wrong
direction will causethe bit to climb out of the work
possibly damaging the bit and!or causing loss of
control.
i i I J
i
i
t '
19