Mounting The Camera - D-Link DCS-6045LKT Guía De Instalación Rápida

mOUNTING THE CAmErA

please refer to the steps below to assist you with mounting the camera. We suggest that you
configure the camera before mounting.
6
Step 1:
place the mounting bracket where you want to position the camera
and use a pencil to mark the holes.
Step 2:
depending on the material of the wall or ceiling, use proper tools to
drill two holes or screws where you placed the mounting sticker. If
the wall is made out of concrete, drill the holes first, insert the plastic
anchors and then the screws. the space between the camera and
the screwheads should be 3 mm.
Step 3:
If desired, the camera power cord can be concealed behind the
mounting bracket. Run the cable through the back of the mounting
bracket, securing it with the built-in guides. Be sure to leave enough
cable length protruding from the top to allow connection to the
camera.
Step 4:
Fasten the mounting bracket to the wall using the screws provided.
Step 5:
using the supplied thumbscrew, fasten the camera to the mounting
bracket. connect the camera power cord to the camera.
Step 6:
adjust the angle of the arm on the mounting bracket as required.
tighten the thumbscrew to lock the arm in place.
DCS-6045L