Application Area; Ambient Conditions; Safety Information; Symbols Used - Renfert Waxprofi Manual De Instrucciones

ENGLISH
1. Introduction
We are pleased with your decision to purchase
a Waxprofi denture wax heating unit.
Please observe the following information in
order to ensure long and trouble-free service.

2. Application Area

The Waxprofi wax heating unit is used to heat
base waxes to their ideal processing tempera-
ture for full and partial dentures.
In the large pot, the wax is held at a liquid,
viscous, or spreadable consistency, as required,
ready for further processing with the preheated
wax knife and Bunsen burner or an electronic
waxing-up instrument.

2.1 Ambient Conditions

(in accordance with IEC 60664-1)
The Waxprofi may only be operated:
• Indoors.
• Up to an altitude of 2,000 m
(6,500 ft) above sea level.
• At an ambient temperature of
5 – 40 °C (41 – 104 °F).
• At a maximum relative humidity of 80 % at
31 °C (87.8 °F), decreasing linearly to 50 %
relative humidity at 40 °C (104 °F).
• With a mains power supply where current
fluctuations do not exceed 10 % of the nomi-
nal value.
• Under Level 2 contamination conditions.
• Under overvoltage category II conditions.
Waxprofi
Nr. 1440-0000 / Nr. 1440-1000

3. Safety Information

3.1 Symbols Used

The following symbols are employed in these
instructions and on the unit:
Danger
An imminent danger of injury exists.
Electrical Power
Danger of electrical shock.
Attention
Failure to observe this information
can result in damage to the unit.
Note
This is a note intended to provide the
operator with useful information to
make operation easier.
For indoor use only.
Before opening the unit, disconnect
it from the power supply by pulling
the wall plug.
3.2 Safety Information
• The Waxprofi is an electrical device with
potential hazards. This unit may only be
locked and used by authorized special-
ist personnel after an examination with
regard to conformity with applicable
national standards.
• Before starting the unit, compare the volt-
age information on the nameplate with the
specifications of your local power supply.
• Units with damaged power cords or other
defects may not be operated.
• During operation, always unroll the power
cord (overheating hazard in case of a
short circuit).
• Liquid waxes can cause burns. Never
move the unit while it is operating!
- 1 - EN