Petsafe Barkender PBC13-13208 Manual De Funcionamiento página 12

4. Check the tightness of the Bark Control Collar by inserting one finger between
the end of a Contact Point and your dog's neck (C). The fit should be snug but
not constricting.
the collar any tighter than is required
for good contact. A collar that is too
tight will increase the risk of pressure
necrosis in the contact area.
5. Allow your dog to wear the Bark
Control Collar for several minutes then
recheck the fit. Check the fit again as
your dog becomes more comfortable
with the Bark Control Collar.
6. Trim the collar as follows (D):
a. Mark the desired length of the
Bark Control Collar with a
pen. Allow for growth if your
dog is young or grows a thick
winter coat.
b. Remove the Bark Control
Collar from your dog and cut
off the excess.
12
You should not make
D
www.petsafe.net
C