Install Glass Sweep And Weather Stripping - Petsafe PPA11-14766 Manual De Instalación

4B. Drill four / " (2.5 mm) holes. DO NOT drill through the
7
64
other side of the sliding glass door or Sliding Glass Pet Door
(Repeat for second latch)
4C. Secure the latches and keepers with 8
screws. DO NOT OVERTIGHTEN (Repeat for second latch).
Helpful Tip: If overtightening results and
you have stripped the connection, move
the latch slightly up or down and re-drill
mounting holes. Another option is to drill
existing holes to a larger size and install
plastic anchors. Plastic anchors can be
purchased at any local hardware or home
improvement store.
Step 5

Install Glass Sweep and Weather Stripping

5A. The glass sweep should be
installed on the back edge
of the sliding glass door to
form a seal between the
sliding glass door and the
stationary glass door. The
weather stripping should be
installed on the front edge
of the sliding glass door to
form a seal between the
Sliding Glass Pet Door and
the sliding glass door.
10
/ " flat head sheet metal
3
4
4C
5A
1-800-732-2677
4B
Sliding Glass
Pet Door
Sliding glass door shown here
slightly open
Sliding Glass Pet Door
Install glass sweep here
Install weather stripping here
Sliding Glass
Pet Door