Tools Required; Measurement And Marking - Petsafe Staywell deluxe 400 Serie Manual De Instalación

Before installing your cat fl ap
please read the following step-by-
step instructions carefully.

Tools required

• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• 5 mm ( / ") drill bit
3
16
• Screwdriver
• Tape measure
• Glue
• Sand paper

Measurement and marking

Measure the belly height of your cat. This is usually 100 mm to
150 mm (Fig. 1).
Mark this measurement on the outside of your door and draw a straight
horizontal line 168 mm (Fig. 2).
Usually this line will be the bottom of the hole you cut in your door – the
frame of the cat fl ap will be slightly lower. With Magnetic cat fl aps it is
important that the cat is able to approach the cat fl ap without obstacle.
There should be a level area in front of the cat fl ap outside which is
suffi cient for the cat to stand with all four paws on the same level.
4
FIG.1
Cutting a hole for your cat fl ap
a) In Wood
The cat fl ap requires a square cut-out of 175 mm x 168 mm (Fig. 3).
FIG.3
Not to scale - for best results you should refer
to the enclosed cutting template.
www.petsafe.net
FIG.2
(x)
(x)
Wooden doors
168 mm
175 mm