Tools Required; Measurement And Marking - Petsafe 200 Serie Guia Del Usuario

Before installing your pet door please
read the following step-by-step
instructions carefully.

Tools required

• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• Screwdriver
• Tape measure
• Sand paper
• Scissors

Measurement and marking

Measure the belly height of your pet (x). This is usually 100 -150mm (4-6") (Fig.1).
Mark this measurement on the outside of your door and draw a straight
horizontal line. (Fig.2).
Please bear in mind that this line is eventually where the bottom
of the hole you cut in your door will be. The frame of the pet door
will be slightly lower. If necessary, this line may have to be raised
slightly to account for this.
3
FIG.1
Cutting a hole for your pet door
a) In Wood and PVC/uPVC/Metal
The pet door requires a circular cut-out with a diameter of 263mm (10
FIG.3
263mm (10 3 / ")
8
Not to scale - for best results you should refer
to the enclosed cutting template.
FIG.2
Wooden doors
3 / "). (Fig.3).
8
PVC/uPVC/Metal