Vroom 88500 Manual Del Usario página 14

Securing the unit....
Step
To completely secure the Vroom there are two options:

To secure to the door frame, use
a black wood screw to secure the
sliding arm (pre-drill: see step 3).
Connect the pre-stripped wires
from the hose management
case to the wires from the
motor compartment using wire
nuts (provided).
Part Number
Model Number
Replacement Filters and Bag Part Numbers
Air Watts
CFM
Sealed Vacuum
Electric Power Cord
Dirt Container Capacity
Voltage
Amperes
Electrical Requirements*
1
OR
OR
To secure to the side wall use a
Philllps screw driver and a black
wood screw (see step 3). CAUTION:
Do not over tighten the screw.
Step
Step
11
1
To secure motor compartment
to the base of the cabinet, peel
the easy release tape. NOTE:
Use the alcohol wipes to clean
base cabinet (included)
VROOM Solo Specifications
* It is recommended that this unit is plugged into a dedicated circuit or a circuit that is
unlikely to be used simultaneously with the Vroom. (i.e. garbage disposal)
Connect the Vroom motor compartment
to the hose management case by
connecting them with flex hose and
hose clamps (included).
9170
Vroom Solo/Model 88500
7767-V Debris Bag (3 Pack)
4929 Filter
4928/4934 Filter Support
450
120
105"
Length 6' Plug Type 15 Amp,
(NEMA type 5-15p) 2 pole, 3 wire
1 Gallon
120 Volts (AC)
11.3 Max/8.5 Avg
120V/15 Amp Circuit. Separate Circuit
Recommended. For 15A Circuit use NEMA 5-15R
Step
10
Step
1
Plug the motor compartment
into a grounded 120V outlet.
You are ready to clean!