Vroom 88500 Manual Del Usario página 8

Connecting to the Vacuum Line
"Through the wall" installations
ATTENTION: Do not glue
the vacuum line to the
black fitting (provided)
on the unit: it is a friction
fit for easy removal.
With the unit in place
trim out the stub
(from your trunk line)
by using tubing to tie
into the Vroom.
Dry fit your assembly with the escutcheon plate (label
side down) and wire in place (the escutcheon plate is
notched for the wire
to run through it along
side the tubing). Glue
and assemble your fit-
tings/tubing and attach
to the trunk line. Do
not glue the vacuum
line to the black fitting
on the unit. Attach the
low voltage wires from
the Vroom to the low
voltage wires coming
from the trunk line
using wire nuts.
Push any
excess wire
through the
escutcheon
plate.
Properly installed unit
To test the unit,
simply lift the
handle out of
the docking
station until you
feel the switch
engage (90
degrees). This
will turn on the
central vacuum
unit and activate
the Vroom.
8
Step
1
14.75"
from floor
to tube
center
Step

Step

Escutcheon
plate
"Floor" & "Retrofit" installations:
It is always best to accurately measure for drilling
considering all possible obstacles. Drill a pilot hole with
1/8" bit (long) and check from lower level to make sure
you will be clearing those obstacles. Make sure you
have access to the trunk line.
ATTENTION: Do not glue the vacuum line to the black
fitting (provided) on the unit: it is a friction fit for easy
removal.
Locate the path for your vacuum line from the trunk
line and make reference marks for drilling. Drill a pilot
Step
1
Using a hole saw bore a
2-1/4" hole through the
cabinet and the floor.
Dry fit your combination
of fittings/tubing to ensure
good positioning. Remove
your dry fit assembly, glue
assembly and attach to the
trunk line. Do not glue the
vacuum line to the black
fitting on the unit. Be sure
to slide the escutcheon onto
the tubing before gluing.
Attach the low voltage wires
from the Vroom to the low
voltage wires coming from
the trunk line using wire
nuts.
Properly installed unit
hole to ensure a clear
path below the cabinet.
Check underneath to
ensure there are no
obstructions before
drilling.
Step

Step

To test the unit,
simply lift the
handle out of the
docking station
until you feel the
switch engage (90
degrees). This will
turn on the central
vacuum unit and
activate the Vroom.