Operating | Getting Started Quickly
Tapping and Wiping: Working with the Touchscreen
Registering mfx Locomotives
Setup: Place the mfx
locomotive completely
on the track. mfx loco-
motives can be done
on both the main track
and on the programming
track.
Simple Access to the Locomotive and Item List
Dragging and Zooming: Thanks to
the high-resolution Touchscreen,
Pulling up the Item List: Touch
simple touches are all you need
the green horizontal bar and pull
to operate this device – such as
down: The item list will open as far
with a Smartphone or a Tablet.
as required. Pulling the horizontal
bar up reduces the item list or
For example, in order to enlarge
the track diagram, you drag with
the thumb and index finger „away
from each other".
Quick Access to the Locomotive Controller
(„Popup Fahrpult" has to be enabled first in the System Settings, see Page 32)
Reading: After several sec-
onds, the CS3 automatically
begins to read the data.
Finished: The newly
entered locomotive appears
outlined in red in the loco-
motive list. A red „m" on
the edge of the locomotive
symbol on the upper end of the control knob
list also refers to the new
registration of the mfx
locomotive.
Pulling up the Locomotive List: The loco-
motive list can be enlarged as required
with the help of the red horizontal bar on its
upper edge. Simply touch the horizontal bar
and pull up. Pulling in the opposite direction
reduces the locomotive list and even hides it
completely.
hides it completely.
Running the Locomotive: Tap on the locomotive sym-
bol. The spontaneous control will open (left image).
You set the speed with your fingertip on the control
knob. You can also set the speed by „pushing up"
on the green bar. Close the spontaneous control by
tapping left or right next to it on the screen.
Calling up Functions: Open the functions
for the locomotive by tapping on the „F"
(right image). You switch the functions on/
off by pressing with your finger.
5