Markin Central Station 3 Montaje E Instrucciones página 69

Editing Settings / Speed
The speed for a locomotive can be changed by means of
the speed bar.
Time Specifications / Entering Delays
Adding Text Information
This is the way adjusting settings works:
Call up the item „Edit event" and tap on
the corresponding procedure. The event
changes to the editing mode, recognizable
from small „x" signs in the squares above
right.
You can enter corresponding time units in
the delay field in order to have proce-
dures match each other exactly in terms
of time. The delay indicates here when
the next event is to be activated.
A component is available with the item
„Text" that allows you to enter infor-
mation when you are to run trains by
schedule.
Sorting Events
Sorting by feedback contacts is recommended
when it is a matter of getting a quick over-
view of the individual occupancy detection
messages.
Using the Recording Function
Manual recording: Set a locomotive on
the track, press the record button, run the
locomotive. A red dot signals that the re-
cording is happening. At the end of the run,
store the locomotive and stop recording
(tap on the button again). Each procedure
element can be edited later on after the
recording (right image).
Overview: All of the routes and
procedures created can be
sorted quite easily by name or
by feedback contacts (S88).
Simply tap on the drop-down
menu in the upper left corner
of the window.
Along with the manual entry of
routes and procedures, with
the CS3 you can also gather
these items by means of a
recording function. Similar to a
video camera, the CS3 records
a procedure here and plays it
back later.
Important: Only the desired
route can be switched when
programming with the record-
ing function.
29