Descargar Imprimir esta página

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56
UK
AUTO
In order to select the auto mode press the ON/OFF button, then press the
MODE button on the remote control until the symbol
During the
operation, the electronic control automatically selects the opera-
tion modes according to the room temperature (measured by the sensor integra-
ted into the Internal Unit):
- If the room temperature is 2°C higher than the one set using the remote con-
trol, the cooling cycle begins while the fan operates at low speed.
- If the room temperature is 1°C lower than the one set using the remote con-
trol, the heating cycle begins.
You can use the mode also by using the switch placed under the Indoor Unit's
frontal panel.
COOLING
In order to select the cooling mode press the ON/OFF button and after the
MODE button on the remote control until the symbol
In this mode the air conditioner cools the room while at the same time reducing
the air humidity. Press the UP and DOWN button to set the desired room tempe-
rature. The appliance automatically adjusts the compressor's running cycles in
order to keep the room at the desired temperature.
Example: If the room temperature is/reaches 28°C, you need to set a tempera-
ture lower than 27°C in order to enable the compressor's cooling cycle.
DEHUMIDIFYING
In order to select the dehumidifying mode press the ON/OFF button and after
the MODE button on the remote control until the symbol
This mode, with its alternating cooling and fan cycles, is designed to obtain the
dehumidification of the air without considerably modifying the room temperature.
The operation is completely automatic: the air conditioner automatically adjusts
the fan speed. If the room temperature is 2°C lower than the temperature set
using the remote control, the appliance runs in the heating mode.
If the room temperature is 2°C lower than or 2°C higher than the temperature
set using the remote control, the alternating operating cycle will start up: the air
conditioner will run for six minutes in the cooling mode and it will stop for four
minutes while the indoor unit's fan will operate at low speed.
22

OPERATION MODES

is displayed.
is displayed.
ALTERNATING CYCLE DIAGRAM
is displayed.

Publicidad

loading