Operating Mode; Clock Setting - MTS BTUh Manual De Usario

UK
* Set temperature
TURBO MODE (only for Inverter and Ambition Models)
The turbo function allows the air conditioner to reach the set temperature in the
fastest way. When the set temperature is reached, the air conditioner will return to
the last set operation mode.
NOTE: In DRY mode, SLEEP and TURBO functions cannot be started/run.
AUTO CLEANING MODE (only for Ambition Model)
This mode, alternating cooling, heating and fan modes, is due to clean the air condi-
tioner. The operation is completely automatic and the appliance operates at low
speed. Once the cycle ends, the appliance will stop automatically.
The function can be started only after COOL or DRY modes.
IONIZER (only for Ambition Models)
This device can generate anions that improve the air quality and the room comfort.
The ionizing device can be started in every operation mode.
FUNCTION NOT IMPLEMENTED (Oxygen generator)
FUNCTION NOT IMPLEMENTED (Movement sensor)
FUNCTION NOT IMPLEMENTED (Energy saving mode)
TIMER OPERATION (ON AND OFF TIMER)
This function allows you to automatically turn the air conditioner on (or off)at the
desired time.
Before setting the On-Timer mode check that the air conditioner is set to the desired

operating mode.

Press the TIMER button until the "ON" symbol starts flashing on the display.
Press the UP, DOWN buttons to change the On-Timer hours and the LEFT and
RIGHT buttons to switch from hours to minutes. In order to confirm the time press
the TIMER button again until the "ON" symbol lights up while the "OFF" symbol
starts flashing. You can set the Off-Timer by following the same procedures.
If you don't press the Up and Down buttons to set the On-Timer and the Off-Timer,
the remote control will not record the setting.
To disable the timer setting press "TIMER" again or wait for 5 seconds without pres-
sing any other button.
CANCEL FUNCTION
Press the CANCEL button to delete the On-Timer and the Off-Timer settings.

CLOCK SETTING

The remote control is provided with an inside clock.
In order to change the time press the CLOCK button for more than a second until
the CLK symbol starts flashing. Press The UP and DOWN buttons to set the correct
hour and the RIGHT and LEFT buttons to pass from hours to minutes.
24
Cooling mode operation
1 hour
2 hours
Heating mode operation
1 hour
2 hours
(*) Set temperature
ON
OFF
CLK