Publicidad
Idiomas disponibles
Idiomas disponibles
HEATING
In order to select the heating mode press the ON/OFF button, then press the
MODE button on the remote control until the symbol
the air conditioner heats the room by means of the heat-pump operation. In this
mode the room is heated using the heat contained in the outside air at a low tem-
perature. Press Up, Down buttons to set a temperature higher than the ambient
temperature set in for the heating cycle to start. The appliance regulates the com-
pressor's running cycles automatically in order to keep the room at the desired tem-
perature.
Example: if the room temperature is 18°C, you need to set a temperature higher
than or equal to 19°C for the compressor to start and heating to begin.
FAN
Press the ON/OFF button, then press the MODE button on the remote control until
the symbol
is displayed. This mode let air circulate throughout the room.
Press the FAN button to choose the fan speed among/select the fan speed until the
required setting is displayed:
By choosing the speed
cally.
AIR MODE
Press the AIR button until the letters "SL" on the remote control are displayed and the
symbols
,
and
flash once and the temperature indicator disappears.
Press the Right and Left buttons in order to select the possible operation modes. Now
the related symbol will now start flashing (faster if the operation is already running).
Press the Up button to enable and the Down button to disable the oxygen genera-
tor (optional) and the auto cleaning mode (Ambition models). You can start the auto
cleaning mode only if the remote control is set on Cooling or Auto.
Press the AIR button again or wait for 5 seconds without pressing any other button
in order to confirm the setting.
ECO MODE
Press the ECO button until the letters "SL" on the remote control are displayed and
the symbols
,
,
and
disappears.
Press the Right and Left buttons in order to select the possible operation modes.
Since you cannot select two operation modes at the same time, every new selec-
tion will cancel the last set mode. Press the Up button to enable and the Down but-
ton to disable the turbo mode
(optional) and the movement sensor
Press the ECO button again or wait for 5 seconds without pressing any other but-
ton in order to confirm the set option's selection/choice.
SLEEP MODE
In cooling or dehumidifying mode the set temperature is gradually increased by 2°C
during the first two running hours. In heating mode the set temperature is gradually
decreased by 2°C during the first two running hours.
Combined with the SLEEP function, you can set the Off-Timer until 24 hours maxi-
mum by pressing the TIMER OFF button, (see the timer-off paragraph).
Note: In "SLEEP" mode you can only set the "TIMER OFF" timed stopping.
(low),
(medium),
the electronic control selects the fan speed automati-
flash once instead of the temperature indicator
, the sleep mode
, the energy saving mode
.
is displayed. In this mode
(high) o
(auto)
UK
+
+
AUTO
CLEAN
+
+
23
Publicidad
Capítulos
