Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS REQUIRED:
2 pcs - H4 Phillips Round Head Screw
1 pc - P5 Electronic Scorer
STEP 3:
Feed P5 Electronic Scorer plug through the hole from side top rail as shown. Connect plug onto C3
Junction Box.
Attach P5 Electronic Scorer onto top rail using pre-drilled pilot holes with H4 Screws as shown in
FIGURE 3.
Install 3 "AAA" batteries (not included) into electronic scorer. To preserve battery life - turn electronic
scorer off when not in use.
PARTS REQUIRED:
2 pcs - A1 Striker
2 pcs - A3 Felt Pad
STEP 4:
Peel the backing off A3 Felt Pad
and attach to A1 Striker as shown
in FIGURE 4.
All Rights Reserved
©
2
0
12
E
c s
a
a l
d
e
S
p
r o
H4
s t
THIS STEP REQUIRES TWO OR MORE ADULTS.
VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON
ITS LEGS. BE CAREFUL, THE TABLE IS HEAVY.
P5
H4
Blower
Motor Cord with
ON/OFF Switch
FIGURE 3
NOTE: A3 Felt Pads may
already be attached to
A1 Strikers.
6
CAUTION:
A3
A1
F
r o
C
u
s
o t
m
r e
S
e
v r
c i
e
FIGURE 4
C
l l a
- 1
888-996-2729
Publicidad
Tabla de contenido
