Technical Specifications; Output Specifications - GF Grafco -3 Manual De Operación

TECHNICAL SPECIFICATIONS

Channel
Modes of Operation
Pulse Intensity
Pulse Width
Pulse Rate
Timer (GF-3T Only)
Burst Mode (B)
Wave Form
Voltage
Power Source
Dimensions
Weight

OUTPUT SPECIFICATIONS

Mode Intensity
(mA)
Burst
Adj. 0-80
Continuous Adj. 0-80
Modulation Adj. 0-80
Dual, isolated between channels
Burst, Continuous, and Modulation
Adjustable 0 mA – 80 mA peak into 500 ohm load each channel,
constant current
30uS-260uS (adjustable)
2 Hz-150 Hz (adjustable)
Continuous, 30 minutes, and 60 minutes
Burst consists of 2 bursts per second at 100 Hz
Asymmetrical bi-phasic square pulse
0 – 100 Volt (open circuit)
9-Volt battery
95 mm x 65 mm x 23.5 (height x width x thickness)
115 g (including battery)
Pulse Width
(uSec)
Adj. 30-260
Adj. 30-260
Modulates down
from preset width
setting by 60%
then back to
original setting
Pulse Rate
Frequency (Hz)
100 Hz fixed N/A
2 bursts per Sec
Adj. 2-150 Hz
Adj. 2-150 Hz
14
Cycle Time
(Sec)
N/A
5 Sec total time