Deleting A Step Or Steps In A Chase; Edit Mode - Chauvet DJ Foot-C Manual De Usuario

Deleting a Step
or Steps in a
Chase

Edit Mode

Page 18 of 88
To delete a step or steps in a chase, do the following:
1. Enter program mode.
2. Press <MODE> until the left display reads CHASE.
3. Use <FUNCTION (ENTER)> to select the chase to be shortened.
4. Use <UP> and <DOWN> to select the step to be deleted.
5. Press and hold <DELETE> for three seconds. The displays will flash, indicating the
step was deleted. All steps after the deleted step will move down the queue to
replace it. For example: If step 3 is deleted, step 4 will become step 3, step 5 will
become step 4, etc.
6. Release <DELETE>.
7. Repeat steps 4–6 until all desired steps have been deleted.
8. Exit program mode or continue programming chases/scenes.
Deleted steps can not be restored without redesigning the look.
To edit a step or steps in a chase, follow the instructions below:
1. Enter program mode.
2. Press <MODE> until the left display reads CHASE.
3. Press <MUSIC / AUTO / BLACKOUT> until the display on the right reads EdIT.
4. Use <FUNCTION (ENTER)> to select the chase to be edited.
5. Use <UP> and <DOWN> to select the step to be edited.
6. Use buttons <1>–<6> to select the fixture(s) to be programmed.
7. Use the Color/Number knobs to set the desired output.
8. Repeat steps 6 and 7 until all fixtures output as desired.
9. Press <PROGRAM> to record the changes. The displays will flash, indicating the
changes were saved.
10. Repeat steps 5–9 until all desired changes to this chase are completed.
11. Edit another chase or exit program mode.
Foot-C User Manual Rev. 2