Installation And Use - RPB L4 Light Manual De Instrucciones

INSTALLATION AND USE

FIGURE 1.1
Remove the Hand strap and ring from
the air inlet fitting at the back of the helmet.
Once removed, insert the base clip of the L4
Light.
FIGURE 1.3
Stretch the L4 Light Band over the top of the
™
helmet and draw it tight to connect the second
hole in the band over the clip.
4 4
™
Tape
FIGURE 1.2
Remove the backing from the double sided
tape on the back of the L4
L4 on the front of the Helmet making sure
™
that the steel clip is securely clipped over the
front of the peak and that the L4 is centered on
the helmet. Then press firmly to make sure the
tape is adhered to the helmet .
FIGURE 1.4
Holding the L4 Light Band in place, push fit
™
the Locking Clip over to secure the band to the
helmet, making sure that the band is sitting
neatly on the center of the helmet and that the
light is held securely in place.
Light. Locate the
™