Prepare For Installation - U.S.Robotics USR5436 Guia De Instalacion

Prepare for installation

Note: Your model number is 5436. You can find your serial number on the bottom label of the
USR5436 Wireless USB Print Server and on the side of the package. Write your serial number
down. If you ever need to call our Technical Support department, you will need this number to
receive assistance.
The Wireless USB Print Server is initially set in Infrastructure mode. If you will be establishing a
wireless connection to a wireless router or access point, the only security that the print server
supports is WEP or WPA-PSK. You may need to modify the security settings of your wireless net-
work accordingly.
Step One:
Connect the square end of a USB cable to the USB port on your printer. Connect the
thin rectangular end of the USB cable to the USB port on the Print Server. Make sure your printer
power cable is plugged in and the printer is turned on.
Step Two:
Connect one end of an Ethernet cable to your wireless or wired router and the other
end to the Ethernet port on the Print Server.
Note: The Wireless USB Print Server must be connected to your network using an Ethernet
cable for the initial configuration. After the initial configuration, you can establish a wire-
less connection.
2