Parkside PGK 1400 A1 Traducción Del Manual De Instrucciones Original página 49

Read this instruction manual
carefully before you start work-
ing with the tool, and familiar-
ise yourself with its controls.
If the power cable for this
equipment is damaged, it
must be replaced with a spe-
cial power cable, which is
available from the manufac-
turer or a customer service
agent of the same.
Please read the following
safety guidelines in order
to avoid risk of fi re, electric
shock, personal injury and
damage to objects:
Preparation:
• This appliance is not intended
for use by persons with reduced
physical, sensory or mental ca-
pabilities, or lack of experience
and knowledge, unless they
have been given supervision or
instruction concerning use of the
appliance by a person responsi-
ble for their safety.
• Children should be supervised to
ensure that they do not play with
the appliance.
• The equipment is to be used only
by people who are adequately
trained.
• Never allow children or other
persons unfamiliar with the user
manual to use the shredder. Lo-
cal regulations or bylaws may
determine the minimum age for
using the device.
• Never use the tool while others,
especially children or pets, are
close by.
• Remember: the user is responsi-
ble for accidents involving other
people or their property.
• Familiarise yourself with han-
dling the tool and pay attention
to all possible dangers that may
be overheard while working with
the tool.
• Check the terrain on which
you will be using the tool, and
remove stones, sticks, wires or
other foreign objects that may be
caught up and spun off.
• Wear proper working clothes,
such as fi rm footwear with non-
slip soles and strong long trou-
sers. Do not use the tool barefoot
or wearing open-toed sandals.
• Use personal protective equip-
ment. Always wear eye protec-
tion. Protective equipment such
as dust mask, non-skid safety
shoes, hard hat, or hearing
protection used for appropriate
conditions will reduce personal
injuries.
• To prevent injury from the tines,
only switch the tool on in its
working position.
• Examine the tool beforehand
every time you use it. Do not use
the tool when the safety compo-
nents (such as the power safety
catch or guard), cutting parts or
bolts are missing, worn or dam-
aged. In particular, check the
mains cable and dead-man lever
for damage.
• Only replace damaged bolts or
tines in complete sets to prevent
imbalance.
• Only use replacement and acces-
sory parts delivered and recom-
mended by the manufacturer. Us-
GB MT
49