Disposal Requirements; Start-Up And Operation - Foster EcoPro G2 Manual De Servicio Original

GB
Important Note to the Installer:
Please ensure that this document is passed to the user as it
contains important guidelines on operation, loading, cleaning
and general maintenance and should be kept for reference.
General Electrical Safety
Foster Refrigerator recommends that the equipment is electrically connected via a Residual
Current Device; such as a Residual Current Circuit Breaker (RCCB) type socket, or through a
Residual Current Circuit Breaker with Overload Protection (RCBO) supplied circuit.

Disposal Requirements

If not disposed of properly all refrigerators have components that can be harmful to the
environment. All old refrigerators must be disposed of by appropriately registered and licensed
waste contractors, and in accordance with national laws and regulations.

Start-Up and Operation

After unpacking, clean and allow the cabinet or counter to stand for 2 hours before turning
on (cleaning directions supplied within this manual). Ensure the cabinet is situated on a firm,
level surface away from both hot and cold air sources, as this will affect its performance.
Vaporiser Tray (Dual Temperature Models Only)
On delivery, the tray is attached to the rear of the cabinet. Remove the two fixing screws and slide
the vaporiser tray underneath the cabinet, into the two fixed runners.
Bend the corner tabs of the tray upwards, then using the guide holes already in the cabinet secure
the tray in position with the two screws originally removed.
The heaters electrical connection to the cabinet will already be in place. Ensure the drain line pipe
is angled in an upright position to form an air lock.
Please make sure that when positioning a dual temperature model with an external vaporiser tray
the tray does not come into contact with any other surfaces.
Clearance (All models)
Make sure that a minimum clearance of 310mm above and 50mm around the
is available for ventilation and effective operation.
Connect the unit to a suitable mains power outlet and turn the supply on. Please do not plug or
unplug the unit with wet hands.
The cabinet will energise briefly showing
blank display. The unit is now in standby.
Standby
Pressing the power switch for 3 seconds will turn the unit on (the switch backlight is static and the
display shows the operating temperature) or into standby (the switch backlight pulses slowly on
and off).
As the operating temperature has been preset no adjustments are required. Allow the cabinet to
reach its normal/set operating temperature before loading.
followed by the power switch slowly pulsing with a
cabinet or counter
1