Bunn SPEED BREW BT Manual De Usuario página 16

CLEANING THE SPRAYHEAD TUBE
Cleaning the sprayhead tube removes deposits formed by
natural mineral content in your water. The more mineral
content in your water, the more you should clean.
A good rule of thumb is to do it every 3 months. If
you have very hard water then twice a month may be
necessary.
You'll need: the deliming tool provided with your
machine, a toothpick, dish soap, and a soft cloth.
• Press the tank power switch to the OFF position,
unplug the coffeemaker and allow it to cool for at least
2 hours.
• Remove the funnel and unscrew the sprayhead,
loosening with your fingertips.
• Insert all but 2 inches of the deliming tool into the
sprayhead tube.
• Slide the deliming tool in and out of the sprayhead
tube 5 or 6 times to loosen any deposits.
• Remove the deliming tool and reinsert the brew funnel.
16
• Pour a carafe of fresh water into the coffeemaker.
• Place the empty carafe on the warmer plate and close the
lid. Water will flow into the carafe.
• Check the sprayhead holes and clear any deposits with
the toothpick.
• Clean the sprayhead with a cloth and dish soap. Rinse it
with water.
• Empty the water from the carafe and place the empty
carafe on the warmer plate.
• Remove the brew funnel and reinstall the sprayhead.
Reinsert the brew funnel.
• Plug in the coffeemaker. Press the tank power switch to
the ON position.
• Wait 15 minutes for the water in the tank to reach brew
temperature.
• Your machine is again ready for brewing.
*NOTE: For a replacement sprayhead or deliming tool call customer
service at 1-800-352-2866 (USA) or 1-800-263-2256 (Canada).