Vox StompLab IIG Manual De Usuario página 14

If you are repeatedly unsuccessful in adjusting
the sensitivity, it is possible that the StompLab has
malfunctioned. Please contact your local VOX dealer.
Restoring the factory preset programs
Here's how to restore (reload) the StompLab's programs back to
the original factory preset programs.
When you perform this operation, all of the programs you
created and stored inside the StompLab will be erased, and
replaced by the factory programs.
1. While holding down the  button and the  button, turn on
the power.

2. The program/value display will indicate " rL ", and the TUNER
#
and LEDs will blink. Take your hand off both buttons you
had been pressing.
If you decide to cancel the reload operation at this point, press
the  button.
3. If you wish to reload the factory settings press the  button.
The program/value display will indicate " Ld " and reloading
will begin. When reloading has completed, the program/value
display will indicate "CP ", and the StompLab will automatically
enter Program select mode.
Never turn off the power while reloading.
14
Troubleshooting
If you suspect a malfunction, please check the following points. If
this does not resolve the problem, please contact a nearby dealer.
1. Power does not turn on
q H ave the batteries have run down?
When the batteries run low, the program/value display will
be dark. We recommend that you replace the batteries as
soon as possible. If batteries become unusable, remove them
immediately. Leaving drained batteries in the unit can cause
malfunctions (such as battery leakage). You should also
remove the batteries if you won't be using the StompLab for
an extended period of time.
q Make sure the batteries are inserted with the polarities (+, -)
in the correct orientation.
q Is the AC adapter connected to the rear panel DC9V jack?
q Is the AC adapter plugged into an AC outlet?
q Could the AC adapter be damaged?
2. No sound
q Is the volume of your guitar turned down?
q Is your guitar cable connected correctly?
q Is your guitar cable broken?
q Are the [AMP/DR] VALUE 1 (GAIN) or VALUE 2 (LEVEL)
parameters currently set to a low value?
q Are the [Lo] or [Hi] parameters currently set to a low value?
For some amp models, there may be no sound from the amp
if the TREBLE, MIDDLE, and BASS control values are low.
q Is the volume turned down for another effect?