Adjust The Image - Axis 225FD Guia De Instalacion

Page 10

Adjust the image

Dome casing
Unit casing
1. Open the Live View page in the Web interface and make the following adjustments:
2. Loosen the pan adjustment ring and tilt adjustment screws. Hold the lens while turning the
pan adjustment ring, otherwise the lens may rotate with the lock ring and damage or
disconnect the cable.
3. Turn the lens to the desired direction. Do not turn the lens more than 360° as this may
cause the internal cables to disconnect.
4. Once satisfied, gently tighten the pan adjustment ring and tilt adjustment screws to secure
the camera's position.
5. Turn the image balance ring to set the image to the correct angle.
6. Loosen the zoom puller counterclockwise, rotate the zoom ring and determine the desired
zoom position.
Note:
Due to the dome's refraction, the image might appear slightly out of focus once the dome has
been placed. To compensate, focus on an object slightly closer than the intended area.
3 tamper-proof
screws
Zoom
puller
Tilt
adjustment
screw
AXIS 225FD Installation Guide
Focus puller
Pan adjustment ring
Tilt
adjustment
screw
Image
balance
ring