Change The Fuses In The Base Unit - Axis Q8665–EPTZ Guia De Instalacion

AXIS Q8665–E PTZ Network Camera

Change the Fuses in the Base Unit

DANGER
Risk of electric shock. Turn off power supply to equipment prior to working inside base unit.
CAUTION
• The electrical connections and conduit installations shall be made by a certified electrician
and in compliance with local regulations.
• Risk of fire. For continued protection against risk of fire, the fuses must be replaced
with the same type and rating.
1. Separate the pan/tilt unit from the base unit by removing the four screws, see section
Hardware Overview.
2. Check the fuses by using a multimeter. If the fuses are blown, change the fuses. See
the table below.
1
Pan/tilt unit
2
Base unit
3
Fuse F1
4
Fuse F2
Fuse Specification
Voltage
24/100 V AC 50/60 Hz
1
2
Fuse F1 5x20
F 6.3 A 250 V
24
3
4
Fuse F2 5x20
T 8 A 250 V