Titan Controls Helios 8 Manual De Instrucciones

®
Helios 8
8 Light - 240 Volt Lighting Controller
Easy Guide Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Please consult with a licensed electrician prior to installation
of the Helios 8. High voltage can be dangerous!
2. Connect 240 volt power to the 3 screws under the protective
cover. (See 'Instructions for Operation' section).
3. Replace protective cover with screws provided.
4. Securely mount your Helios 8, with hardware provided, near
the ballasts to be operated. It should be placed away from
water, mist, spray, etc.
TM 5. Plug your 240 volt ballasts into the multi-tap outlets on the
left and right side of the controller.
6. Plug the relay activation cord set into Apollo Series wall timer.
7. Your Helios 8 will now control your ballasts at the desired
settings until the power is defeated.
Sun System
Sun System
Sun System
Sun System
Ground Hot Neutral
Controlling a light bank
R
to 240 Volt Ballast
R
to 240 Volt Ballast
Helios 8
240 Volt
R
to 240 Volt Ballast
to 50 Amp
to 240 Volt Ballast
Power Source
R
Titan Apollo
24 HR
120 Volt
Timer
Hot
Wiring
diagram
Controller Specifi cations
Size: 13"H x 11"W x 4"D
Weight: 10 lbs.
Voltage Input: 240 volts
Voltage Output: 240 volts
Maximum Amperage: 40 amps
Maximum Wattage: 8000 Watts
Hertz: 60 Hz
Time Switch: Two(2)120 Volt relay trigger cord sets
Operating Temperature: 40° to 125° F | 5° to 52° C
Storage Temperature: 32° to 135° F | 0° to 57° C
to 240 Volt Ballast
Sun System
to 240 Volt Ballast
Sun System
to 240 Volt Ballast
to 120 Volt
Timer
to 240 Volt Ballast
Sun System
Titan Apollo
24 HR
120 Volt
Timer
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Sun System
R
R
R
R
®