Titan Controls Helios 1 Guía Sencilla

®
Helios 1
TM
4 Light - 120 volt Lighting Controller
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Please consult with a licensed electrician prior to installa-
tion of the Helios 1. High voltage can be dangerous!
2. Connect 120 volt power to the 3 screws under the pro-
tective cover. (See 'Instructions for Operation' section).
3. Replace protective cover with screws provided.
4. Securely mount your Helios 1, with hardware provided,
near the ballasts to be operated. It should be placed
away from water, mist, spray, etc.
5. Plug your ballasts into the outlets on the left and
right side of the controller.
6. Set the timer to current time of day.
7. Turn on Helios 1 power switch to activate
lighting controller.
8. Your Helios 1 will now control your ballasts at
the desired settings until the power is defeated.
Controlling a light bank
Wiring
diagram
Controller Specifications
Size: 11"H x 11"W x 4"D
Weight: 4 lbs.
Voltage Input: 120 volts
Voltage Output: 120 volts
Maximum Amperage: 50 amps
Maximum Wattage: 4000 Watts
Hertz: 60 Hz
Time switch: 24 hour with 15 minute increments
Operating Temperature: 40o to 125o F | 5o to 52o C
Storage Temperature: 32o to 135o F | 0o to 57o C
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
®