JMA MULTICODE DUPLA Manual De Uso página 79

The limit is referenced by the red line drawn on the representation of the cut of the key. That way, in this example it
indicates Limit 0 and in the neck of the key. In the cases limit 1 or 2 the point of the key, and using the point limit plate
in the channels of face 1 of the jaw MP1.
See Chapter 3.2 referring to the tooth jaw, to see the limits and the indications of how to attach the key.
We can perform two actions in the file.
A) Key reading
Like in the case of the toothed keys in the reading of keys shows us the biting code of the key and on the other
hand the read height of the key.
The point and channel keys are read with the 1P feeler that already includes the vertical head. See Chapter 3.3.2.2
B) Key machining
The key machining is just as easy as reading, it consists of attaching the key well and after introducing the biting
cutting either directly (or by obtaining a code) or after the reading of an original key, we command the machining.
The biting of the key can be changed at any time by writing in the biting box.
MULTICODE DUPLA
KEY CUTTING MACHINE
79