Residual Risks; Electrical Safety; Description (Fig. A) - METAWOOD MTTM2000-355 Traducción De Las Instrucciones Originales

cut. They may be sharp and hot. Allow cut off
parts to cool before handling.
• The spark defl ector becomes hot during use.
Avoid touching or adjusting the spark defl ector
immediately after operation.
• Switch off the tool and wait for the cutting disc to
stop before moving the workpiece or changing
the settings.
• After switching off, never attempt to stop the
cutting disc by pressing against the side of the
disc.
• Do not use cutting fl uids. These fl uids could
ignite or cause electrical shock.
• Check that the workpiece is properly supported.
• Use the cutting discs recommended by the
manufacturer only. Never use circular saw blades
or any other types of toothed blades.
• The max. allowable speed of the cutting disc must
always be equal to or greater than the no-load
speed of the tool specifi ed on the nameplate.
• Do not use cutting discs that do not conform to
the dimensions stated in the technical data.
• Ensure that the cutting disc is mounted correctly
before use.
• Let the tool run at no-load in a safe position for
at least 30 seconds. If there is a considerable
vibration or if any other defect occurs, stop the
tool and check it to determine the cause.
• Do not use cutting discs for side grinding.
• Do not cut concrete, brick, tile or ceramic
materials.
• Do not cut wood, plastic or synthetic materials.
• Do not cut cast-iron materials.
• Never cut magnesium materials.
• Do not cut electrically live material.
• Use this tool in a well-ventilated area. Do not
operate the tool near fl ammable liquids, gases or
dust. Sparks or hot chips from cutting or arcing
motor brushes may ignite combustible materials.
• Regularly clear the ventilation slots when working
in dusty conditions. If it should become necessary
to clean the slots, remember to unplug the tool fi rst.
• Always store cutting discs well-protected and in
a dry place, out of reach of children.
• Only use chop saw wheel of a a max. thickness of
3.1 mm and a max. diameter of 355 mm.
• Warning! Use of this tool can generate dust
containing chemicals known to cause cancer, birth
defects or other reproductive harm.
Use appropriate respiratory protection.
The following factors are of infl uence to noise
production:
– the material to be cut
– the type of the cutting disc
– the feed force
Take appropriate measures for

RESIDUAL RISKS

• The following risks are inherent to the use of
these machines:
– injuries caused by touching the rotating
parts.
– injuries caused by disruption of the
cutting disc.
• These risks are most evident:
– within the range of operation
– within the range of the rotating machine
parts
• In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of accidents caused by the
uncovered parts of the rotating cutting disc.
– Risk of injury when changing the disc.
– Risk of squeezing fingers when opening
the guards.

ELECTRICAL SAFETY

Always check that the power

DESCRIPTION (fig. A)

Your cut-off machine for metal has been
developed for cutting metal workpieces.
1 On/off switch
2 Lock-off button
3 Operating handgrip
4 Guard
5 Scale for mitre angle
6 Vice
7 Table top
8 Fence
9 Depth stop
10 Carbon brush holder
11 Transport handgrip
Replacing the cutting disc (fig. B)
Only use sharp and undamaged cutting discs.
Cracked or bent cutting discs must be
replaced immediately.
19
the protection of hearing.
supply corresponds to the
voltage on the rating plate.