Connection To Your Personal Computer - NEC MultiSync LCD1510 Manual De Usuario

E - 8
Installation

Connection to your Personal Computer

The MultiSync LCD
complements PC compatible computers. Your system has one of two
configurations:
– the video controller is built into the computer.
– the video controller is in the form of a display card (sometimes
referred to as graphics card, video adapter or graphics board).
Both configurations have a video connector (or a CRT PORT on laptop
computers). If you are not sure which connector is the video connector,
refer to your computer or display card manual.
To attach the monitor to your system, follow these instructions:
1. Turn off the power to the monitor and computer.
2. If necessary, install the display card. For more information about
installing your card, refer to the display card manual.
3. Connect the 15-pin mini D-SUB of the appropriate signal
cable to the connector of the display card in your computer.
Tighten all screws (Figure A.1).
4. For the MultiSync LCD
the 15-pin mini D-SUB of the video signal cable and the AC
Adapter cable to the appropriate connectors on the back of the
monitor (Figure C.1).
For the MultiSync LCD
of monitor. Connect the BNC cables and AC adapter cable to
the appropriate connectors on the back of the monitor. Connect
the red BNC cable to the BNC connector on the monitor labeled
R, the green BNC cable to the BNC connector labeled G/Sync,
the blue BNC cable to the BNC connector labeled B. If you
have a fourth BNC connector (Composite Sync), connect it to
the BNC connector on the monitor labeled H/CS. If you have a
fifth BNC connector (Vertical Sync), connect it to the BNC
/ LCD
1510 1510V
, MultiSync LCD
1510
: Remove connector cover on back
2010
/ LCD true colour monitor
2010
1510V
Installation
: Connect