Publicidad
Idiomas disponibles
Idiomas disponibles
DO YOU HAVE - sQUARE - ROUND - OR OTHER - cROssBARs?
SQUARE
SNAP AROUNDS:
Loosen
the tabs by
bending them
repeatedly.
ROUND
SNAP AROUNDS:
Attach 2 on the front crossbar
and 1 on the back crossbar.
MIGHTY MOUNTS:
OTHER
Universal MightyMount #03590
Follow the Universal MightyMount
instructions and refer to this Raptor
instruction for correct installation.
securing your bike.
Set your bicycle in the wheel
tray with the hoop lying flat
between the wheels.
NOTE: The front wheel of the
bicycle must rest inside the hoop.
1033038H-3/12
Remove the tabs
with scissors or
pliers.
Set tray/hoop assembly onto crossbars.
• Insert two MightyMount bolts down
Attach 2 on the
through the MightyMounts and baseplate.
front crossbar
• Tighten with hex wrench.
and 1 on the
• Insert a SnapAround bolt through the
back crossbar.
SnapAround on the other crossbar.
• Secure with short hex key.
INsTAll END cAPs.
RAISE hoop,
ROLL bicycle
forward as jaws
meet the down tube.
Set tray/hoop assembly
onto crossbars.
• Insert two bolts
up through the
SnapArounds and
baseplate.
• Secure with
elongated hex keys.
• Insert the remaining bolt
through the SnapAround
on the other crossbar.
• Secure with short hex
key.
In the open position, Jaws should clear the bike
frame. Raptor can mount above or below most
attachments, such as waterbottles.
SOME attachments on the down tube must be removed if the
jaws cannot attach above or below them.
Tighten all 3 hex
keys firmly onto all
SnapArounds.
NOTE: Hoop must rest
horizontally on tray while
turning the hex keys. When
hoop is raised the hex keys
cannot be turned.
Tighten rear hex
key firmly onto
SnapAround..
Tighten red
knob.
NOTE:
To avoid paint
wear, clean
contact points
on frame before
tightening Jaws.
overtighten.
Do not
Publicidad
