Amplicom PowerTel 680 Guia Del Usuario página 57

Register wrist shaker
Important: It is necessary to register the wrist shaker if it has become
de-registered from the telephone or if a new wrist shaker needs to be
registered.
At the wrist shaker:
1. Turn on the wrist shaker by pressing and holding
2. After the wrist shaker is On, press and hold
until the registration light fl ashes green. The wrist shaker will be in
registration for about 1 minute.
At the corded phone base:
3. Press and hold
is displayed (for about 10 seconds).
Note: To located the registration key
corded phone base at the beginning of this guide.
4. The registration light unit glows a steady green when the wrist shaker is
registered (i.e. it isn't fl ashing).
Note: the registration light will fl ash green and red if the wrist shaker
either isn't registered or is out of range.
1-866-AMPLICOM (267-5426)
for at least 10 seconds, until Register
for about fi ve seconds.
again for about 12 seconds,
, see the At a Glance section for the
W S
RIST HAKER
57