Operations - Bissell CLEANVIEW 1320 Serie Guia Del Usuario

Operations

power switch
The Power switch on model 1320 series is
located on the left side of the vacuum. Push
the rocker switch "ON" (i) to vacuum, and
"OFF" (O) when cleaning is complete.
notE: you can find your model number on
the back, bottom side of the vacuum on the
white sticker by the Ul rating.
handle position
Press the handle release pedal with your foot
to place your CleanView vacuum into one of
three cleaning positions.
1. Upright – For storage and above floor
cleaning with tools.
2. Normal cleaning – Press handle release
for household floor cleaning tasks.
3. Low cleaning – With the vacuum in
normal cleaning position, press handle release
pedal again, use for reaching under low furniture
such as tables, chairs or beds.
height adjustment
There are five height settings available for
various floor surfaces. Turn the dial on the foot
of the cleaner to the desired setting.
Lowest setting – For low pile carpet or bare
floors. To pick up debris, it may be necessary
to move up one setting.
Medium setting – For medium pile carpet.
Highest setting – For high pile and most
shag carpet.
notE: for optimal carpet cleaning performance,
adjust to the lowest practical setting. If your
cleaner is difficult to push, adjust to the next
higher setting.
if the dial is difficult to turn, tilt the cleaner
back slightly to take the weight off the foot
while turning.
Tips
*Product images may vary
» Hair, string and small objects can
block the vacuum hose or tools.
Check them occasionally
for obstructions.
Before using your vacuum, make sure that the dirt
tank is in the locked position and that both filters
(pre-motor and post-motor) are in place. Do not
operate your vacuum without these filters.
» Before cleaning under low furni-
ture, check area first for objects
that might harm the unit or block
the vacuum hose.
caUtIon
» Your vacuum features a Quick
Release™ cord wrap. To remove
the power cord quickly and
easily, rotate the upper cord
wrap toward the floor and slip
the power cord off the upper and
lower cord wraps.
www.bissell.com
7