Operations - Bissell POWERGLIDE Guia Del Usuario

Operations

Powering on
1. To turn on the vacuum, locate the power
switch and move it to the "on" position (I)
2. Recline your vacuum by pressing your
foot down on the foot of the vacuum and
pulling back on the handle.
3. Once cleaning is complete, turn the vacuum
off by switching it to the "off" position (o).
Brush switch
1. For carpet cleaning, turn on the brushroll by
moving the button to the brush position.
2. For hard surface cleaning, turn the brush off,
by switching it to the "off" position (o).
NOTE: The brush roll will automatically shut
off in the following scenarios:
1. When the vacuum is locked in the
upright position.
2. If large debris is clogged in the brushroll.
In this instance, the brush will completely power
off disabling both the brush roll and the brush
roll switch. Follow instructions on page 12 to
reset the brush.
Transporting Cleaner
1. The cleaner can be moved by using the carry
handle –or–
2. With the vacuum in the upright position,
tilt the cleaner back on its rear wheels and
push forward.
Variable Suction
To decrease the amount of suction to clean
delicate carpets, curtains or area rugs, twist the
variable suction valve counter clockwise. .
NOTE: the vacuum will come with the variable
suction valve closed for full suction power.
Tip
» Before cleaning under low furniture, check area
first for objects that might harm the unit or block
the vacuum hose.
www.BISSELL.com
6
NOTICE
Before using your vacuum, make sure that the dirt container is in
locked position and that all filters (pre-motor and post-motor) are
in place. Do not operate your vacuum without these filters.
1.
NOTICE
Always place vacuum cleaner on floor in its fully
upright position and make sure it is locked into
place. Placing the vacuum in its full
upright position automatically
stops the rotating brush.
2.
1.