Typical Installations - Joneca Ready H2OT Guía De Instalación Y Operación

Faucet line connects to the cold
water supply with quick-connect
fitting or compression fitting
(not supplied)
Faucet line connects to filtered cold
water supply for dual handle faucets
¼" (6.35mm)
white tubing to supply inlet
Supplied quick-connect fitting
Water inlet tube
STEP 4 - Connect Cold Water Supply
Refer to installation instructions included with faucet if necessary. Cold water is supplied to the tank through the
faucet. Connect the cold water line to the faucet as shown below.
- Make sure the cold water connecting to the faucet is fi ltered.
- It is suggested that a shut-off valve be installed between this connection and the cold water supply line.
- Another common installation method is with the use of a saddle valve. If a saddle valve is used, follow the
manufacturer's installation guides.
- Connection to a hot water supply is not recommended. If a water fi lter is used, water pressure to the
tank should not drop below 35psi (2.4 bar).
Faucet line
to tank
Silicone hose to
tank
STEP 5 - Check for Leaks
Open valve in water line. Turn faucet on to fi ll tank (about 1 minute). When tank is full, water will fl ow from
faucet. Turn faucet off. Check for leaks.
STEP 6 - Prepare for Power
Double check the thermostat control dial is in the OFF position. Thermostat control dial controls the water
temperature, not the water fl ow or delivery.
Faucet Image Representational

TYPICAL INSTALLATIONS

Faucet line
to cold
Shut-off valve
water
supply
Quick-connect or
Compression fitting
(not supplied - size may vary)
Dual Handle Faucet (Single Handle Faucet not shown)
Connect silicone hose to the center
outlet tube on top of tank. Tighten
the connection with ¼" or 3⁄8" hose clamp
Connect faucet inlet line to the
rear tube at the top corner of the tank
with the quick -connect fitting
Connector/Reducer Adapter
Center outlet
"T" connection with
Shut -off valve
T connector
Cold water supply
(6)