Joneca Ready H2OT Guía De Instalación Y Operación página 8

CARE AND USE
ADJUSTING THE THERMOSTAT
Factory temperature pre-set
is 190°F (88°C) ±5°.
thermostat to that setting, turn
the indicator two notches
to the right of vertical.
CLEANING THE FAUCET AND TANK
Only use mild cleaners to clean the
faucet and plastic components.
Cleaners with acids, abrasives,
alkaline or organic solvents will
result in deterioration of the plastic
components and void the warranty.
Electric Shock Hazard: To prevent electrical shock, disconnect power before
servicing unit. Use only a properly grounded and polarized electric outlet.
+
To reset the
-
Adjust the thermostat
slowly, turning the dial
clockwise to increase temperature
or counter clockwise to decrease
temperature, then activate faucet
handle for 20 seconds to bring in fresh
water to be heated at the new setting.
Allow 5-7 minutes for water to reach
new temperature.
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
PROPERTY DAMAGE
Regularly inspect the unit for any signs
of leakage. If there are signs of water
damage, immediately remove the unit
from service.
To avoid water damage from leakage,
replace all cut, loose or split tubing.
A drain pan, plumbed to an appropriate
drain or outfitted with a leak detector,
should be used in those applications
where any leakage could cause
property damage.
MAX
MIN
approx. 194°
For fresher tasting water,
add filtration to your
instant hot water
dispenser system. For
more information, call
1-888-856-6322.
.
RED AND GREEN LIGHTS
(8)
The Green light indicates
Hot Water is available.
The Red Light indicates
water is heating to
maximum adjustment.