TOPINOX UltraVent VarioCooking Center UV111 Manual De Instrucciones página 20

Dear customer,
please read this installation manual care-
fully before installing the hood.
Damages based on installation not comply-
ing with the directives given hereunder are
not covered by warranty terms..
Ultravent complete
Parts picture 1
Pos. Description
1 Support plate
2 Mounting frame
3 Supporting channel
4 Leg lower part
5 Leg upper part
6 Cover panel
7 HT-pipe
8 Lid HT-pipe
Parts picture 2
Pos. Description
9 Ultravent
Installation
1. Delivery
Carefully unpack the unit on delivery
and check to ensure that no damage
has been caused in transit (follow the
instructions on the packaging).
2. Installation
Attention
Observe the weight of the units.
Use carrying aid to avoid injuries.
Net weight:
Ultravent 112 145 kg
®
Ultravent 211 153 kg
®
Ultravent 311 246 kg
®
- Place support plate (item 1) into the bot-
tom cross bar of the unit
(The folded edge must point to the rear
of the unit)
GB
- Fix mounting frame (item 2) with 4
screws M10 x 25 and washers to the
support plate.
Don't tighten the screws
- Align the frame and tighten the screws.
60.70.806
- Remove cover panel (item 6) from
supporting channel (item 3).
- Unscrew legs (item 4/5)
Art. Number
Insert screw with washer into the upper
36.004.029
part of the leg and the hole of the lower
36.004.028
part of the supporting channel (item 3).
36.004.027
Fasten screw using M10 nut and
12.00.224
washer. Screw lower part of the leg
12.00.205
completely back in again
36.004.106
60.70.897
- Put the supporting channel (item 3) on
2070.0053
the mounting frame and fasten it with 6
screws M8x16 and washers
- Make sure that the fold of the supporting
60.70.891
channel sits on the upper side of the
fold of the mounting frame.
- Undo lower part of the legs until they
stand firmly
- Lift up the hood (item 9) and hold it to
the supporting channel from the front
side
- First guide the drain pipe of the hood
through the hole of the supporting
channel
- Lift up the hood a bit more and swivel it
to the rear, until the folded edge of the
hood engages at the supporting
channel.
Now the hood can be released.
Fix the hood with 2 screws M8x16 and
washers to the supporting channel
at the top side
pic. 3
- 20 -
pic. 4
pic. 5
pic. 6/7
pic. 8
pic. 9
pic. 10
pic. 11
pic. 12
V 06