Dynamic Customisation; Technical Notes; Demounting / Mounting Of The Foot Shell; Demounting - Streifeneder GO.adventure 5A440 Serie Instrucciones De Uso

4.3 Dynamic customisation

Desired result
Harder toe
response
Softer toe
response
Harder heel
response
Softer heel
response

5 Technical Notes

5.1 Demounting / Mounting of the Foot Shell

Use the 5M400 mounting horn to put the foot shell on / off. The mounting
horn makes it easier to slide the prosthetic foot into the foot shell.

5.2 Demounting

18/40
Adjustments during
customisation
Tilt the foot in direction plantar
fl exion or move the load line to
the rear
Tilt the foot in direction dorsal
extension or move the load line to
the front
Tilt the foot in direction dorsal
extension or move the load line to
the front
Tilt the foot in direction plantar
fl exion or move the load line to
the rear
During demounting, the heel should
hang over a table edge. This helps to
lever the heel out of the foot shell and
therefore makes it easier to take it off.
Components
exchange
–
–
Insert heel wedge
(see pt. 6)
Remove heel
wedge
(see pt. 6)