3. Setup
AC Power
AC Plug
Power Linking
PVP™ X3 User Manual, Rev. 1
Each PVP™ X3 has an auto-ranging power supply that works with an input voltage
range of 100–240 VAC, 50/60 Hz. To determine the power requirements for each
PVP™ X3, refer to the label affixed to the product. You can also refer to the
Specifications
chart in this manual.
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download Sizing Circuit Breakers from the Chauvet
website: www.chauvetprofessional.com.
· Always connect this product to a protected circuit with an appropriate
electrical ground to avoid the risk of electrocution or fire.
· To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Each PVP™ X3 comes with a power linking cord to connect power between panels; and
a power input cord.
This cable has a powerCON® connector to connect to the PVP™ X3 and an Edison plug
for power input. Use the table below as a reference to wire a new plug.
Connection
AC Live
AC Neutral
AC Ground
All panels in the PVP™ Series support power linking. Refer to the following table for
specifications on each panel.
@ 120 V, 60 Hz
@ 208 V, 60 Hz
@ 230 V, 50 Hz
Please refer to all applicable local codes and regulations for the proper installation
of this product.
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
Screw Color
Brown
Yellow or Brass
Blue
Silver
Green
PVP™ X3
16
29
32
Setup
Technical
7